www.eagletreesystems.com
Hi I have a guardian on a stryker it works fine in 3d but 2d only works when I first set the plane level and reset guardian after a flight or two if...
As I use my EagleTree OSD Pro v4 more and more, I like it a lot. Its already very feature rich, but there are a few suggestions i have ( and will...
eagle tree osd,v logger,gps ran return to home simulator i didnt do the throttle up or evevator on display the arrow started moving out by self....
Hi there, A bit at a loss here so all advice really welcome! I've been using my eagletree setup (OSD, elogger 3, guardian) for a couple of...
I´v got some issues with a ET E-Logger V3 + GPS and Video OSD (not the PRO). I have connected all together, but I only can see the OSD on my...
Suddenly my OSD stop driving the servos and throttler. Video and data is transmitted OK from the OSD but aileron /elevator and throttler outputs...
Hi guys; Every time I run the servo wizard I am getting the following error message (see attachment). I start getting such an error after I...
Question 1 : i want to swap my rudder for airlon on rth. now the rudder servo is going straight to rudder receiver ch 4. the airlon servo is going to...
So, yep, I want a very stabilized flight. I'm talking like glass, cause that's how I roll... or don't want to roll... plus I fly a SS and hate it......
Hya, Been using my GPS (and eagletree elogger and OSD and guardian) successfully for a couple of years now. The GPS is currently buried in the...
I just got the OSD Pro Expander with the 10Ghz GPS Expander and the v4 Data Logger. Do I need any other add-ons to get the Artificial Horizon to...
Is there any problem in moving the Ferrite Ring two inches further away from the GPS ? Would make for a neater install if I could just mount the GPS...
Is this a bug or? I found the radar north/up offset only allows 0 to 345 degrees... What about 346 to 359? Anyone know how to set it to 350? ...
Hi everyone! This is my first post on this great forum, but I´ve reading it long time ago. The problem is that my Guardian Expander seems to...
Had a crash fairly recently and discovered today that my OSD Pro doesn't turn on, nor does the GPS and altimeter when powered from a 4S lipo, but...
I have ordered the Eagle Tree OSD Pro, V4 logger and PS for the phantom. I was suggested that I need to connect from the AUX of the OSD to the...
so I enabled voice alerts thru the software on my pc but I dont actually get any voice during flight on my 8inch monitor and have audio connected,,,,...
Hi everyone i m using a secondary RPM brush-less sensor connected to the Logger’s THROTTLE input (sensor is modified in the way mentioned in the...
EagleTree, can you tell me more about the "Disable PCM Glitch Detection" in the OSDpro menu? There is nothing in the user manual about it. I just...
Is there a short cable that can be used for USB plug in when the eLogger V4 is buried deep in the fuse? Very hard to get down to it and get the USB...
Use this control to limit the display of threads to those newer than the specified time frame.
Allows you to choose the data by which the thread list will be sorted.
Order threads in...
Note: when sorting by date, 'descending order' will show the newest results first.
Forum Rules
