www.fpvmanuals.com
FPVManuals.com was created to enable threads to 'graduate' from a long discussion, Q&A, banter, and off-topic material to a condensed, concise, and...
The QAV400 — a new FPV quadcopter frame based on the inovations in the QAV500, but in a much smaller form factor. The QAV400 is 100mm smaller in size...
With so many good videos out there all spread out i figured the FPV manuals forum needed a QAV500 video thread, so post your videos here people! here...
The newly available brushless gimbal control boards are quickly bringing commercial grade aerial videography to the masses in an affordable way....
Hi Everyone, and hello to any follows I have from the Open Pilot community as well. I wish I could have posted this over there too, but I have...
This is the pre-release information of the new QAV500 FPV Quadcopter Frame by fpvmanuals. This frame is unique from other FPV focused quad frames for...
As some of you know, I've worked at Sony for the past 10 years as the CTO of Sony Music's digital group. I've been speaking with my friends at the...
UPDATE: Page is up: http://www.fpvmanuals.com/tricopter The kit is ready and available in the stores: http://www.getfpv.com/ |...
We all have issues right? My current nagging issue is CCW yaw drift. After the mysterious Flip-of-Death that I documented in the QAV500 Carnage...
just received my qav500 and was wondering what flight controller would be best naza or cc3d? and why? i have done lots of reading and think i know...
Here's my stab at a travel case for the road. So far it's worked great!
Reaching out to Tim or anyone who has some information. Wanted to order up a QAV400, are they in stock?? Thanks!
hi trying to simplify and instead of running the vtx and cam off a 2s battery i would like to power it off the pdb. how are most folks doing...
Hi When will these prop adapters be back in stock ? Regards Henrik :)
CC3D has become one of the most sought after flight controllers due to its crisp response and smooth flight characteristics. The OP community of...
The rev 2 of LayerLens for the GoPro 3 is finally done. http://www.getfpv.com/layerlens-for-gopro3.html ==== ORIGINAL POSTING DELETED ====
Hi guys, I am ordering parts for my QAV500 and only props are left to decide. Need your help, I couldn't find much about it. I have already...
I received my CC3D fpvmanuals editon board almost 2 weeks ago. And have been trying to get it setup the whole time. Hooked it all up Did the...
I've been looking into the issue that an APC prop does not come with locating rings to make them fit the M4 shaft of a DT-750 motor. I made a little...
Hi, I have TBS 900 motors with m5 thread and running 9x5 graupners. I have hard time centering the prop on the shaft as it can travel sideways...
A beautiful spring morning just begs for a little stick time don't you agree? I took my first QAV500 out to my favorite corn field for a flight this...
Use this control to limit the display of threads to those newer than the specified time frame.
Allows you to choose the data by which the thread list will be sorted.
Order threads in...
Note: when sorting by date, 'descending order' will show the newest results first.
Forum Rules
