schnellschnell
8th January 2012, 11:54 PM
Hello all, I have finally finished my quad and have flown 5 packs so far in it. Setup is a Jakub 450 frame, Tiger 900kv motors, GWS 10x6x3 props, Spektrum (I know, I know) AR8000, Plush 30A and the DJI WKm FC. I also have a Camera and IRC 600mW 5.8 GHz.
GPS hold is quite amazing. It was very windy the other day and it was holding station like a champ. Even my 11 year old flew it. Though in GPS mode you more 'tell it where to go' and it flies itself.
This spring I will be building a plane for FPV but for now I might try it on my quad. Problem is where to put it - how far realistically does it need to be from the Rx / FC / IMU. The GPS / compass is mounted high, with a copper clad board under it which I hope helps.
Should the vTx be on the landing gear (right by the ESCs), on the boom or on the bottom of the center plate? Not sure where to start.
593459355936
Jason
GPS hold is quite amazing. It was very windy the other day and it was holding station like a champ. Even my 11 year old flew it. Though in GPS mode you more 'tell it where to go' and it flies itself.
This spring I will be building a plane for FPV but for now I might try it on my quad. Problem is where to put it - how far realistically does it need to be from the Rx / FC / IMU. The GPS / compass is mounted high, with a copper clad board under it which I hope helps.
Should the vTx be on the landing gear (right by the ESCs), on the boom or on the bottom of the center plate? Not sure where to start.
593459355936
Jason